ILLUMINATED ENTRY SYSTEM
The illuminated entry system has the following control functions:
| Control | Outline | Lights that Operate |
|---|---|---|
| Actuation Area-linked | When a registered key is brought within any vehicle exterior detection area around the doors, the lights that operate turn on. | ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| Door Lock/Unlock-linked | When any door is unlocked, the lights that operate turn on. | ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| When all doors are locked, the lights that operate turn off. | ||
| Door Open/Close-linked | When any door is opened, the lights that operate turn on. | ·
Power Switch Illumination ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| When all doors are closed, the lights that operate turn off. | ||
| Power Switch-linked | When the power switch is turned from on (ACC) or on (IG) to off, the lights that operate turn on. | ·
Power Switch Illumination ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| When the power switch is turned from off to on (ACC) or on (IG), the lights that operate turn off. | ·
Power Switch Illumination ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly |
|
| Shift Position-linked | When the shift lever is moved from P to any other position, the lights that operate dim. | ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| Delay | When approximately 15 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·
An actuation area-linked function is used. ·
The door unlock-linked function is active. ·
Any door is opened and then all doors are closed when the power switch is off. ·
The power switch is turned from on (ACC) or on (IG) to off when all doors are closed. |
·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| When approximately 40 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·
Any door is opened and then all doors are closed when the power switch is off. ·
The power switch is turned from on (ACC) or on (IG) to off when all doors are closed. |
Power Switch Illumination |
*1: w/ Rear Door Inside Handle Illumination Light
*2: w/ Instrument Panel Ambient Illumination Light
BATTERY SAVING CONTROL SYSTEM
The battery saving function has the following control functions:
| Control | Condition | Lights that Operate |
|---|---|---|
| Basic operation | When 20 minutes elapse after the power switch is turned from on (ACC) or on (IG) to off and the lights that operate remain on, the lights are turned off.
|
·
Power Switch Illumination ·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Footwell Light (No. 1 Interior Illumination Light Assembly) ·
Front Door Inside Handle Illumination Light (No. 1 Interior Illumination Light Assembly) ·
Rear Door Inside Handle Illumination Light (No. 2 Interior Illumination Light Assembly)*1 ·
Instrument Panel Ambient Illumination Light (Instrument Panel Light Assembly)*2 |
| Interior light auto cut operation | When 20 minutes elapse after the power switch is turned from on (ACC) or on (IG) to off and the lights that operate remain on, the lights are turned off.
|
·
Map Light (Roof Console Box Sub-assembly) ·
Spot Light Assembly ·
Vanity Light Assembly ·
No. 1 Luggage Compartment Light Assembly ·
Courtesy Light Assembly |
*1: w/ Rear Door Inside Handle Illumination Light
*2: w/ Instrument Panel Ambient Illumination Light