Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2017.09–2017.12
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0329891 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Blower Motor does not Operate  


DESCRIPTION

If air does not flow from the front registers after the blower switch on the air conditioning control panel (radio and display receiver assembly)*1 or air conditioning control assembly*2 is operated, the following factors may be the cause.

Symptom Factor
Blower motor does not operate at all

(Air does not blow from registers)


·

Air conditioning amplifier assembly malfunction

·

Blower motor with fan sub-assembly malfunction

·

Warm-up control

·

Engine coolant temperature sensor malfunction

·

Harness or connector



*1: w/ No. 1 Stereo Jack Adapter Assembly

*2: w/o No. 1 Stereo Jack Adapter Assembly


PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM (MANUAL MODE)
a.

Turn off the AUTO switch, operate the blower switch and check that the blower motor with fan sub-assembly can be operated manually.

OK:

The blower motor with fan sub-assembly operates normally.



Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS

NG

GO TO OTHER DIAGNOSIS PROCEDURE (Blower Motor Circuit)

2.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List.


e.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
HINT:
·

After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.

·

If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats if the value indicated is higher than 135°C (275°F).



Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205
OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG