Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330500 LICENSE PLATE LIGHT ASSEMBLY G

LIGHTING (EXT)  LICENSE PLATE LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81270 1.INSPECT LICENSE PLATE LIGHT ASSEMBLY

E125017C58
1.042,1.833 1.458,1.417 false 2.354,1.833 1.969,1.427 false 0.24,0.094 0.49,0.302 0.25,0.208 10 false *a 0.917,1.823 1.073,2.021 0.156,0.198 10 false E 2.365,1.833 2.521,2.031 0.156,0.198 10 false B
*a Component without harness connected
(License Plate Light Assembly)


a.

Connect 4 dry-cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.



b.

Apply 6 V batter voltage to the terminals of the connector and check that the license plate light illuminates.

OK:
Condition Specified Condition
Positive (+) lead from the batteries → Terminal 1 (B)
Negative (-) lead from the batteries → Terminal 2 (E)
License plate light illuminates


If the result is not as specified, replace the license plate light assembly.