Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330505 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84153 1.INSPECT AUTO HIGH BEAM SWITCH

E365728C02
2.552,2.448 2.26,2.063 false 2.25,2.49 2.042,2.063 false 1.99,2.573 1.844,2.083 false 1.573,2.594 1.635,2.073 false 1.219,2.563 1.417,2.073 false 0.969,2.427 1.198,2.063 false 0.115,0.104 0.427,0.302 0.313,0.198 10 false *a 2.552,2.458 2.948,2.698 0.396,0.24 10 false ILL- 2.281,2.531 2.677,2.771 0.396,0.24 10 false E 1.896,2.635 2.292,2.875 0.396,0.24 10 false IND+ 1.427,2.635 1.823,2.875 0.396,0.24 10 false AZBI 1.052,2.594 1.448,2.833 0.396,0.24 10 false +B 0.75,2.448 1.146,2.688 0.396,0.24 10 false ILL+
*a Component without harness connected
(Auto High Beam Switch)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (+B) - 2 (E) Auto high beam switch not pressed 10 kΩ or higher
Auto high beam switch pressed Below 1 Ω


If the result is not as specified, replace the auto high beam switch.


b.

Illumination Inspection

i.

Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the auto high beam switch.



c.

Indicator Inspection

i.

Apply auxiliary battery voltage to the auto high beam switch and check that the indicator illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 3 (IND+)
Auxiliary battery negative (-) → Terminal 4 (AZBI)
Illuminates


If the result is not as specified, replace the auto high beam switch.