84340
1.INSTALL STOP LIGHT SWITCH ASSEMBLY
|
Insert in this Direction |
Insert the stop light switch assembly until the threaded sleeve hits the pedal.
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
|
Turn in this Direction |
Turn the stop light switch assembly 1/4 clockwise to install it.
or less
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
Connect the connector.
Check the protrusion of the plunger.
| Area | Measurement |
|---|---|
| a | 0.6 to 2.6 mm (0.0236 to 0.102 in.) |
If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.
for LHD:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT
for RHD:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT
Do not depress or support the brake pedal.
55606
2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55606
3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)