Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › 2017.09–2021.02
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330506 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

E367717C01
1.469,0.333 1.906,0.583 0.438,0.25 0.938,1.76 1.323,1.188 true 1.781,1.781 2,1.177 true 2.26,1.813 2.198,1.177 true 1.552,0.375 2.01,0.573 0.458,0.198 10 false A37 0.74,1.802 1.135,2.031 0.396,0.229 10 false GND 1.74,1.823 1.958,2.042 0.219,0.219 10 false B 2.229,1.833 2.448,2.052 0.219,0.219 10 false B 0.219,0.198 0.677,0.396 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


a.

Disconnect the A37 stop light switch assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A37-7 (B) - A37-2 (GND) Power switch off 11 to 14 V
A37-6 (B) - A37-2 (GND) Power switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
A37-2 (GND) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness or connector.


c.
E233300C67
1.5,0.344 1.854,0.594 0.354,0.25 1.917,1.115 2.396,1.677 true 2.063,1.104 2.615,1.417 true 1.792,1.115 1.969,1.677 true 1.677,1.104 1.156,1.667 true 0.906,1.531 1.552,1.104 true 0.188,0.115 0.417,0.281 0.229,0.167 10 false *a 1.573,0.396 2.021,0.656 0.448,0.26 10 false A37 2.646,1.406 3.094,1.625 0.448,0.219 10 false OUT 1.979,1.708 2.292,1.917 0.313,0.208 10 false L 2.302,1.719 2.802,1.938 0.5,0.219 10 false GND 1,1.698 1.448,1.958 0.448,0.26 10 false ACC 0.781,1.458 1.094,1.667 0.313,0.208 10 false L
*a Component with harness connected
(Stop Light Switch Assembly)


Connect the A37 stop light switch assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A37-1 (OUT) - A37-2 (GND) Power switch off, brake pedal not depressed Below 1 V
A37-1 (OUT) - A37-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
A37-3 (L) - A37-2 (GND) Power switch off, brake pedal not depressed Below 1 V
A37-3 (L) - A37-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
A37-4 (ACC) - A37-2 (GND) Power switch off 11 to 14 V
A37-5 (L) - A37-2 (GND) Power switch on (IG), brake pedal not depressed 11 to 14 V
A37-5 (L) - A37-2 (GND) Power switch on (IG), brake pedal depressed Below 1 V


If the result is not as specified, replace the stop light switch assembly.