These DTCs are stored if a CAN communication malfunction occurs between the headlight ECU sub-assembly RH and other ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U0073 | Control Module Communication Bus OFF | The headlight ECU sub-assembly RH does not send/receive data. | CAN communication system | HL AutoLeveling (Sub) |
| U0126 | Lost Communication with Steering Angle Sensor Module | The headlight ECU sub-assembly RH does not receive data from the steering sensor for approximately 10 seconds or more. | ·
CAN communication system ·
Steering sensor |
HL AutoLeveling (Sub) |
| U0142 | Lost Communication with Body Control Module "B" | The headlight ECU sub-assembly RH does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) |
HL AutoLeveling (Sub) |
| U0182 | Lost Communication With Lighting Control Module Front | The headlight ECU sub-assembly RH does not receive data from the headlight ECU sub-assembly LH for approximately 10 seconds or more. | ·
CAN communication system ·
Headlight ECU sub-assembly LH |
HL AutoLeveling (Sub) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling (Sub) / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Wait 20 seconds or more.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling (Sub) / Trouble Codes.
Check for DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING