Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM › 2017.09–2020.08
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0331705 GRILLE SHUTTER SYSTEM U

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM  TERMINALS OF ECU  


CHECK SWING GRILLE ACTUATOR ASSEMBLY


B438341C05
2.813,0.188 3.177,0.438 0.365,0.25 3.823,0.188 4.188,0.438 0.365,0.25 2.875,0.229 3.333,0.427 0.458,0.198 10 false z26 3.219,0.229 3.677,0.427 0.458,0.198 12 false *A 3.896,0.229 4.354,0.427 0.458,0.198 10 false A46 4.24,0.219 4.698,0.417 0.458,0.198 12 false *B
*A w/ End Shaft Switch *B w/o End Shaft Switch


a.

Disconnect the z26*1 or A46*2 swing grille actuator assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
z26-1 (+B) - Body ground*1 - Auxiliary battery power supply Power switch off 11 to 14 V
A46-1 (+B) - Body ground*2 LA-G - Body ground
z26-3 (GND) - Body ground*1 - Ground Always Below 1 Ω
A46-3 (GND) - Body ground*2 W-B - Body ground

*1: w/ End Shaft Switch

*2: w/o End Shaft Switch