The air conditioning control assembly communicates with the air conditioning amplifier assembly via LIN communication.
If a malfunction occurs in the LIN communication system, the air conditioning amplifier assembly will not operate, even if the air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with air conditioning control assembly | ·
Air conditioning control assembly ·
Harness or connector ·
Air conditioning amplifier assembly |
Memorized
(10 sec. or more)* |
*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the K26 air conditioning control assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K26-2 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K26-6 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K54 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K26-9 (LIN1) - K54-14 (LIN1) | Always | Below 1 Ω |
| K26-9 (LIN1) or K54-14 (LIN1) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the K54 air conditioning amplifier assembly connector.
Turn the power switch on (IG).
Using an oscilloscope, check the waveform.
Waveform is similar to that shown in the illustration.
| Item | Content |
|---|---|
| Terminal No. | K54-14 (LIN1) - Body ground |
| Tool Setting | 2 V/DIV., 20 ms./DIV. |
| Condition | Power switch on (IG) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Air Conditioning Control Assembly) |
Connect the K26 air conditioning control assembly connector.
Turn the power switch on (IG).
Using an oscilloscope, check the waveform.
Waveform is similar to that shown in the illustration.
| Item | Content |
|---|---|
| Terminal No. | K26-9 (LIN1) - Body ground |
| Tool Setting | 2 V/DIV., 20 ms./DIV. |
| Condition | Power switch on (IG) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG