Home › Engine / Hybrid System › CRUISE CONTROL › FORWARD RECOGNITION CAMERA SYSTEM › 2017.09–2020.08
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0331759 FORWARD RECOGNITION CAMERA SYSTEM C

CRUISE CONTROL  FORWARD RECOGNITION CAMERA SYSTEM  C1AAD  Vehicle Information Initialization Incomplete  


DESCRIPTION

When the forward recognition camera is replaced with a new one, the new forward recognition camera attempts to store the vehicle information received from the hybrid vehicle control ECU assembly. If the forward recognition camera cannot store the vehicle information, DTC C1AAD is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AAD Vehicle Information Initialization Incomplete After the power switch is turned on (IG) for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, the vehicle information from the hybrid vehicle control ECU assembly cannot be stored for 5 seconds or more.
·

Hybrid control system

·

Motor generator control system

·

Forward recognition camera



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



PROCEDURE

1.CHECK FOR DTCs (HYBRID CONTROL SYSTEM)
HINT:

If DTC C1AAD is stored, the hybrid control system may be malfunctioning. Check for DTCs related to the hybrid control system first.


a.

Check for DTCs.

Powertrain > Hybrid Control > Trouble Codes
50001 397

Result:
Result Proceed to
Hybrid control system DTCs are not output A
Hybrid control system DTCs are output B



A

2.CHECK FOR DTCs (MOTOR GENERATOR CONTROL SYSTEM)

B

2.CHECK FOR DTCs (MOTOR GENERATOR CONTROL SYSTEM)
HINT:

If DTC C1AAD is stored, the motor generator control system may be malfunctioning. Check for DTCs related to the motor generator control system first.


a.

Check for DTCs.

Powertrain > Motor Generator > Trouble Codes
50001 395

Result:
Result Proceed to
Motor generator control system DTCs are not output A
Motor generator control system DTCs are output B



A

3.CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)

B

3.CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)
a.

Clear the DTCs.

Chassis > Front Recognition Camera > Clear DTCs
50002 386

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG) and wait 3 seconds or more.

2.

Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.




c.

Check for DTCs.

Chassis > Front Recognition Camera > Trouble Codes
50001 386

Result:
Result Proceed to
DTC C1AAD is not output A
DTC C1AAD is output B



A

B

REPLACE FORWARD RECOGNITION CAMERA