MULTIPLEX TILT AND TELESCOPIC ECU
| *a | Component with harness connected
(Multiplex Tilt and Telescopic ECU) |
- | - |
Measure the voltage and resistance according to the value(s) in the table below.
Inspect the connectors from the back side while the connectors are connected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K72-1 (GND) - Body ground | W-B - Body ground*1
LA - Body ground*2 |
ECU ground | Always | Below 1 Ω |
| K72-2 (+B) - K72-1 (GND) | B - W-B*1
LA-B - LA*2 |
Motor power source | Always | 11 to 15.5 V |
| K72-3 (CANP) - K72-11 (CANN) | R - W | CAN communication | Power switch off | 54 to 69 Ω |
| K72-4 (E1) - Body ground | BE - Body ground | Tilt sensor ground | Always | Below 1 Ω |
| K72-5 (VC) - K72-18 (MSW) | L - GR | Tilt and telescopic switch signal | Power switch on (IG) | 4.9 to 5.1 V |
| K72-6 (TEM+) - K72-1 (GND) | LA-B - W-B*1
LA-B - LA*2 |
Telescopic motor output | ·
Power switch on (IG) ·
Steering column contracting |
11 to 14 V |
| Telescopic motor not operating | Below 1 V | |||
| K72-7 (TIM+) - K72-1 (GND) | LA-LG - W-B*1
LA-LG - LA*2 |
Tilt motor output | ·
Power switch on (IG) ·
Steering wheel tilting up |
11 to 14 V |
| Tilt motor not operating | Below 1 V | |||
| K72-8 (GND2) - Body ground | W-B - Body ground*1
LA - Body ground*2 |
ECU ground | Always | Below 1 Ω |
| K72-9 (ECUB) - K72-1 (GND) | G - W-B*1
LA-BR - LA*2 |
ECU power source | Always | 11 to 15.5 V |
| K72-10 (IG) - K72-1 (GND) | L - W-B*1
LA-L - LA*2 |
IG signal / IG power source | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| K72-13 (VCI) - K72-4 (E1) | B - BE | Tilt sensor power source | Power switch on (IG) | 8 to 14 V |
| K72-14 (VCE) - K72-17 (E2) | GR - LG | Telescopic sensor power source | Power switch on (IG) | 8 to 14 V |
| K72-15 (TES) - K72-17 (E2) | R - LG | Telescopic sensor signal | Telescopic motor operating | Pulse generation
HI: 8 to 14 V LOW: Below 1 V |
| K72-16 (TIS) - K72-4 (E1) | W - BE | Tilt sensor signal | Tilt motor operating | Pulse generation
HI: 8 to 14 V LOW: Below 1 V |
| K72-17 (E2) - Body ground | LG - Body ground | Telescopic sensor ground | Always | Below 1 Ω |
| K72-19 (TEM-) - K72-1 (GND) | LA-G - W-B*1
LA-G - LA*2 |
Telescopic motor output | ·
Power switch on (IG) ·
Steering column extending |
11 to 14 V |
| Telescopic motor not operating | Below 1 V | |||
| K72-20 (TIM-) - K72-1 (GND) | LA-L - W-B*1
LA-L - LA*2 |
Tilt motor output | ·
Power switch on (IG) ·
Steering wheel tilting down |
11 to 14 V |
| Tilt motor not operating | Below 1 V |
*1: for LHD
*2: for RHD