The ECU power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2620A2 | ECU Power Source Circuit System Voltage Low | The voltage of the ECU power source drops to 8 V or less for 10 seconds or more. | ·
ECU-B NO. 2 fuse ·
Harness or connector ·
Multiplex tilt and telescopic ECU |
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
Disconnect the K72 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K72-9 (ECUB) - Body ground | Power switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Multiplex Tilt and Telescopic ECU) |
Disconnect the K72 multiplex tilt and telescopic ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K72-8 (GND2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG