The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during occupant detection ECU removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
·
Replacement of the occupant detection ECU
·
Removal/installation of the front passenger seat
|
Zero point calibration (Occupant classification system)
|
·
Occupant classification system
·
Passenger airbag ON/OFF indicator
·
Airbag system (Front passenger side)
·
Seat belt warning system (Front passenger)
|
( )
|
| Disconnect cable from negative auxiliary battery terminal
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
( )
|
| Pre-collision system
|
| Memorize steering angle neutral point
|
Parking assist monitor system
|
( )
|