Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2017.09–2021.02
RM33C0E _58 Vehicle Interior _065461 PRE-COLLISION _0332154 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C1A02  Vehicle Information Not Obtained  


DESCRIPTION

When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information from the main body ECU (multiplex network body ECU) and stores the information.

DTC C1A02 is stored when the millimeter wave radar sensor assembly receives the vehicle specification information from the main body ECU (multiplex network body ECU) but cannot store it.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A02 Vehicle Information Not Obtained When the vehicle is being driven at a speed of 50 km/h (32 mph) or more, the millimeter wave radar sensor assembly does not have stored vehicle information for 1 second or more. Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT



PROCEDURE

1.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed of 50 km/h (32 mph) or more for 1 second or more.




c.

Check for DTCs.

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC C1A02 is not output A
DTC C1A02 is output B



A

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY