The millimeter wave radar sensor assembly receives steering angle information from the steering sensor. If the millimeter wave radar sensor assembly detects a steering sensor malfunction, DTC C1A47 will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A47 | Steering Angle Sensor | While the vehicle is being driven at a speed of 50 km/h (32 mph) or more, the millimeter wave radar sensor assembly receives a steering sensor malfunction signal continuously for 1 second or more. | ·
Electronically controlled brake system ·
Millimeter wave radar sensor assembly |
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Pre-collision system DTC C1A47 may be stored due to a malfunction in the electronically controlled brake system. Therefore, it is necessary to check for and troubleshoot electronically controlled brake system DTCs first.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Electronically controlled brake system DTCs are not output | A |
| Electronically controlled brake system DTCs are output | B |
A
B
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Drive the vehicle at a speed of 50 km/h (32 mph) or more for 1 second or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A47 is not output | A |
| DTC C1A47 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B