These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision system control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0125 | Lost Communication with Yaw Rate Sensor Module | When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the yaw rate sensor (airbag sensor assembly) and millimeter wave radar sensor assembly is detected for approximately 1 second. | ·
CAN communication system ·
Yaw rate sensor (Airbag sensor assembly) ·
Millimeter wave radar sensor assembly |
| U0126 | Lost Communication with Steering Angle Sensor Module | When the power switch is on (IG), a communication error between the steering sensor and millimeter wave radar sensor assembly is detected for approximately 4 seconds. | ·
CAN communication system ·
Steering sensor ·
Millimeter wave radar sensor assembly |
| U0129 | Lost Communication with Brake System Control Module | When the power switch is on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and millimeter wave radar sensor assembly is detected for approximately 3 seconds. | ·
CAN communication system ·
Skid control ECU (Brake booster with master cylinder assembly) ·
Millimeter wave radar sensor assembly |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | When the power switch is on (IG), a communication error between the combination meter assembly and millimeter wave radar sensor assembly is detected for approximately 8 seconds. | ·
CAN communication system ·
Combination meter assembly ·
Millimeter wave radar sensor assembly |
| U0293 | Lost Communication with Hybrid Vehicle Control System | When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the hybrid vehicle control ECU assembly and millimeter wave radar sensor assembly is detected for approximately 5 seconds. | ·
CAN communication system ·
Hybrid vehicle control ECU assembly ·
Millimeter wave radar sensor assembly |
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Drive the vehicle at a speed of 5 km/h (4 mph) or more for 8 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U0125, U0126, U0129, U0155 and U0293 are not output | A |
| DTC U0125, U0126, U0129, U0155 or U0293 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING