Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2017.09–2019.02
RM33C0E _58 Vehicle Interior _065463 SEAT BELT _0332568 FRONT SEAT INNER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: w/ Occupant Classification System

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Occupant detection ECU

·

Front passenger seat*1


Zero point calibration (Occupant classification system)
·

Occupant classification system

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Hide 73240 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.

Disconnect each connector.


b.

Disengage each clamp.


c.
B470012

Remove the nut and front seat inner belt assembly.


d.
B470013C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.


Hide 73230 4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.

w/ Wire Harness:

i.

Disconnect each connector.


ii.

Disengage each clamp.



b.
B470009

Remove the nut and front seat inner belt assembly.


c.
B470010C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.