Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2017.09–2021.02
RM33C0E _58 Vehicle Interior _065463 SEAT BELT _0332568 FRONT SEAT INNER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73240 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SEAT) (w/o Occupant Classification System)

B276694C40
0.188,0.135 0.344,0.271 0.156,0.135 10 false *a
*a Component without harness connected
(Front Seat Inner Belt Assembly (Driver Seat))


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 2 Driver side seat belt unfastened Below 1 Ω
3 - 2 Driver side seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the front seat inner belt assembly (driver seat).


Hide 73240 2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (FRONT PASSENGER SEAT) (w/o Occupant Classification System, w/ Front Passenger Seat Belt Warning System)

B337570C14
1.021,0.25 1.458,0.521 0.438,0.271 1.896,0.25 2.333,0.521 0.438,0.271 1.469,2.719 1.906,2.99 0.438,0.271 0.073,0.063 0.385,0.26 0.313,0.198 10 false *a 1.104,0.302 1.417,0.5 0.313,0.198 10 false R71 1.99,0.302 2.323,0.542 0.333,0.24 10 false R70 1.49,0.292 1.865,0.656 0.375,0.365 10 false *A 2.385,0.292 2.698,0.49 0.313,0.198 10 false *B 1.635,2.781 1.948,2.979 0.313,0.198 10 false B
*A for LHD
*B for RHD
*a Component without harness connected
(Front Seat Inner Belt Assembly (Front Passenger Seat))


a.

Measure the resistance according to the value(s) in the table below (seat belt warning switch).

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
R71-3 - R71-2 Front passenger side seat belt unfastened Below 1 Ω
Front passenger side seat belt fastened 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
R70-3 - R70-2 Front passenger side seat belt unfastened Below 1 Ω
Front passenger side seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the front seat inner belt assembly (front passenger seat).


b.

Measure the resistance according to the value(s) in the table below (occupant detection sensor line).

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
R71-5 - B-1 Always Below 1 Ω
R71-4 - B-3 Always Below 1 Ω

for RHD
Tester Connection Condition Specified Condition
R70-5 - B-1 Always Below 1 Ω
R70-4 - B-3 Always Below 1 Ω


If the result is not as specified, replace the front seat inner belt assembly (front passenger seat).