Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Fully tighten the bolt (A) and then the bolt (B) to install the front shoulder belt anchor adjuster assembly.
73220
2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
73220
3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Engage the 2 guides and temporarily install the front seat outer belt assembly with the 2 bolts.
Fully tighten the bolt (A) and then the bolt (B) to install the front seat outer belt assembly.
| *a | Locking Button |
| *b | Lock |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Check that the ELR locks.
This check should be performed with the front seat outer belt assembly installed to the vehicle.
With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.
62412B
4.INSTALL UPPER CENTER PILLAR GARNISH
62414A
5.INSTALL LOWER CENTER PILLAR GARNISH
73220
6.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Connect the floor anchor of the front seat outer belt assembly with the bolt.
73233
7.INSTALL LAP BELT OUTER ANCHOR COVER
Engage the 3 claws to install the lap belt outer anchor cover.
62332A
8.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
67918A
9.INSTALL REAR DOOR SCUFF PLATE
62312B
10.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
67914
11.INSTALL FRONT DOOR SCUFF PLATE
12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
64718C
13.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
14. PERFORM DIAGNOSTIC SYSTEM CHECK
15.INSPECT SRS WARNING LIGHT