73432
1.INSTALL REAR SEAT BELT RETRACTOR COVER
|
Install in this Direction |
Install the rear seat belt retractor cover as shown in the illustration.
Use the same procedure for the RH side and LH side.
73370E
2.INSPECT REAR SEAT OUTER BELT ASSEMBLY
73370E
3.INSTALL REAR SEAT OUTER BELT ASSEMBLY LH
Engage the guide and temporarily install the rear seat outer belt assembly LH with the 2 bolts.
Fully tighten the bolt (A) and then the bolt (B) to install the rear seat outer belt assembly LH.
| *a | Locking Button |
| *b | Lock |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Check that the ELR locks.
This check should be performed with the rear seat outer belt assembly LH installed to the vehicle.
With the rear seat outer belt assembly LH installed to the vehicle, check that the belt locks when it is pulled out quickly.
73360D
4.INSTALL REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
64330
5.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
Engage the 3 clips and 5 guides.
Install the package tray trim panel assembly with the 2 clips.
Return the rear seatback assembly LH and rear seatback assembly RH to their original position.
64330
6.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
Engage the 3 clips.
73373F
7.INSTALL REAR SEAT SHOULDER BELT HOLE COVER
Engage the 2 guides and 2 claws to install the rear seat shoulder belt hole cover.
Use the same procedure for the other rear seat shoulder belt hole covers.
81006
8.INSTALL CENTER STOP LIGHT SET
73370E
9.CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
|
Protruding Part |
Connect the floor anchor of the rear seat outer belt assembly LH with the bolt.
Do not allow the anchor part of the rear seat outer belt assembly LH to overlap the protruding parts of the floor panel.
73360D
10.CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
62472A
11.INSTALL INNER ROOF SIDE GARNISH LH
62471A
12.INSTALL INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
13.INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
62332A
14.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type)
15.INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
Use the same procedure as for the LH side.
62331A
16.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)
72693
17.INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
18.INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
73350C
19.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)
20.INSTALL REAR SEAT ASSEMBLY (for Reclining Seat Type)
21.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
64718C
22.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
23. PERFORM DIAGNOSTIC SYSTEM CHECK
24.INSPECT SRS WARNING LIGHT