87910
1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
Check the operation of the mirror surface.
If the mirror surface is fully turned to the right, left, upward or downward position, the motor slips and produces a clicking noise. This is not a malfunction.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Disconnect the outer rear view mirror assembly RH connector.
Apply auxiliary battery voltage and check the operation of the mirror surface.
| Auxiliary Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+) |
Turns upward |
| Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV) |
Turns downward |
| Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+) |
Turns left |
| Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly RH.
Check the operation of the mirror heater. (w/ Mirror Heater)
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Disconnect the outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 11 (E) | 25°C (77°F) | 10 to 17 Ω |
If the result is not as specified, replace the outer rear view mirror assembly RH.
Connect a cable from the positive (+) auxiliary battery terminal to terminal 2 (+) and the negative (-) auxiliary battery terminal to terminal 11 (E), then check that the mirror becomes warm.
It takes a short time for the mirror to become warm.
Mirror becomes warm.
If the result is not as specified, replace the outer rear view mirror assembly RH.
Check the operation of the retractable mirror. (w/ Power Retract Mirror)
Disconnect and reconnect the auxiliary battery between each mirror position check.
The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.
If the motor is kept energized, even after each mirror position check, it may lead to a motor malfunction. Make sure to disconnect the auxiliary battery immediately after performing each mirror position check.
| *a | (A) Forward Position |
| *b | (B) |
| *c | (C) Driving position |
| *d | (D) |
| *e | (E) Retracted Position |
| *f | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Disconnect the outer rear view mirror assembly RH connector.
For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror's movement.
| Auxiliary Battery Connection | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Forward position (A) | Moves from (A) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Forward position (A) | Does not move |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Position between forward position (A) and driving position (C) | Moves from (B) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Position between forward position (A) and driving position (C) | Moves from (B) to (A) |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Driving position (C) | Moves from (C) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Driving position (C) | Does not move |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Position between driving position (C) and retracted position (E) | Moves from (D) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Position between driving position (C) and retracted position (E) | Moves from (D) to (C) |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Retracted position (E) | Does not move |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Retracted position (E) | Moves from (E) to (C) |
If the result is not as specified, replace the outer mirror retractor RH.
87940
2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
Check the operation of the mirror surface.
If the mirror surface is fully turned to the right, left, upward or downward position, the motor slips and produces a clicking noise. This is not a malfunction.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Disconnect the outer rear view mirror assembly LH connector.
Apply auxiliary battery voltage and check the operation of the mirror surface.
| Auxiliary Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+) |
Turns upward |
| Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV) |
Turns downward |
| Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+) |
Turns right |
| Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH) |
Turns left |
If the result is not as specified, replace the outer rear view mirror assembly LH.
Check the operation of the mirror heater. (w/ Mirror Heater)
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Disconnect the outer rear view mirror assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 11 (E) | 25°C (77°F) | 10 to 17 Ω |
If the result is not as specified, replace the outer rear view mirror assembly LH.
Connect a cable from the positive (+) auxiliary battery terminal to terminal 2 (+) and the negative (-) auxiliary battery terminal to terminal 11 (E), then check that the mirror becomes warm.
It takes a short time for the mirror to become warm.
Mirror becomes warm.
If the result is not as specified, replace the outer rear view mirror assembly LH.
Check the operation of the retractable mirror. (w/ Power Retract Mirror)
Disconnect and reconnect the auxiliary battery between each mirror position check.
The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.
If the motor is kept energized, even after each mirror position check, it may lead to a motor malfunction. Make sure to disconnect the auxiliary battery immediately after performing each mirror position check.
| *a | (A) Forward position |
| *b | (B) |
| *c | (C) Driving position |
| *d | (D) |
| *e | (E) Retracted position |
| *f | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Disconnect the outer rear view mirror assembly LH connector.
For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror movement.
| Auxiliary Battery Connection | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Forward position (A) | Moves from (A) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Forward position (A) | Does not move |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Position between forward position (A) and driving position (C) | Moves from (B) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Position between forward position (A) and driving position (C) | Moves from (B) to (A) |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Driving position (C) | Moves from (C) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Driving position (C) | Does not move |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Position between driving position (C) and retracted position (E) | Moves from (D) to (E) |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Position between driving position (C) and retracted position (E) | Moves from (D) to (C) |
| Auxiliary battery positive (+) → Terminal 3 (MR)
Auxiliary battery negative (-) → Terminal 9 (MF) |
Retracted position (E) | Does not move |
| Auxiliary battery positive (+) → Terminal 9 (MF)
Auxiliary battery negative (-) → Terminal 3 (MR) |
Retracted position (E) | Moves from (E) to (C) |
If the result is not as specified, replace the outer mirror retractor LH.