85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
for High Pressure:
Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Center of washer fluid contacts the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Measurement | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 35.8 cm (1.17 ft.) | B | 161.7 mm (6.37 in.) |
| C | 297.5 mm (11.7 in.) | - | - |
If the result is not as specified, replace the washer nozzle sub-assembly.
for Standard:
Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Washer fluid contacts the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Measurement | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 34.8 cm (1.14 ft.) | B | 186.6 mm (7.35 in.) |
| C | 239 mm (9.41 in.) | - | - |
If the result is not as specified, replace the washer nozzle sub-assembly.