Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR
RM33C0E _59 Vehicle Exterior _065471 WIPER / WASHER _0332915 HEADLIGHT CLEANER MOTOR G

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

HINT:

This check should be performed with the headlight cleaner motor and pump assembly installed to the washer jar.


a.
E190232C17
0.167,0.115 0.521,0.385 0.354,0.271 10 false *a
*a Component without harness connected
(Headlight Cleaner Motor and Pump Assembly)


Remove the washer jar.


b.

Disconnect the headlight cleaner motor and pump assembly connector.


c.

Fill the washer jar with washer fluid.


d.

Connect a positive (+) lead from the auxiliary battery to terminal 2 and a negative (-) lead to terminal 1 of the headlight cleaner motor and pump assembly connector.


e.

Check that washer fluid flows from the washer jar.

OK:

The headlight cleaner motor and pump assembly operates and washer fluid flows from the headlight cleaner motor and pump assembly.


If the result is not as specified, replace the headlight cleaner motor and pump assembly.