Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY
RM33C0E _59 Vehicle Exterior _065471 WIPER / WASHER _0332916 HEADLIGHT CLEANER CONTROL RELAY G

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

a.

Disconnect the headlight cleaner control relay connector.


b.
E303137C05
1.688,0.917 1.688,0.438 true 1.396,0.906 1.396,0.438 true 1.396,1.688 1.396,1.24 true 1.969,1.677 1.969,1.24 true 1.344,0.25 1.656,0.448 0.313,0.198 10 false IG 1.646,0.25 1.958,0.448 0.313,0.198 10 false H 1.354,1.74 1.667,1.938 0.313,0.198 10 false PB 1.938,1.729 2.25,1.927 0.313,0.198 10 false E 0.156,0.125 0.469,0.323 0.313,0.198 10 false *a
*a Component without harness connected
(Headlight Cleaner Control Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (PB) - 4 (E) Auxiliary battery voltage applied between terminals 3 (IG) and 2 (H) Below 1 Ω
Auxiliary battery voltage not applied between terminals 3 (IG) and 2 (H) 10 kΩ or higher


HINT:

If the result is not as specified, replace the headlight cleaner control relay.