Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B14C1 | Front Left Seat Heat Sensor Circuit | Seat heater temperature sensor malfunction | ·
Air conditioning amplifier assembly ·
Front Seat Cushion Heater Assembly LH ·
Wire harness or connector |
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
DTC B14C1 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Remove the front seat cushion heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL
Inspect the front seat cushion heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>INSPECTION
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL
Disconnect the b17 front seat cushion heater assembly LH connector.
Disconnect the K55 and K56 air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K56-17 (TSL) - b17-4 | Always | Below 1 Ω |
| K56-17 (TSL) or b17-4 - Body ground | Always | 10 kΩ or higher |
| K55-8 (SG-5) - b17-5 | Always | Below 1 Ω |
| K55-8 (SG-5) or b17-5 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG