Use the following procedure to troubleshoot the seat heater system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer to confirm the problem.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| Air conditioning system DTCs are output | B |
| Seat heater system DTCs are output | C |
A
B
C
Refer to Problem Symptoms Table.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Operation Check
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK
Terminals of ECU
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>TERMINALS OF ECU
Data List / Active Test
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DATA LIST / ACTIVE TEST
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT