Use this procedure to troubleshoot the climate control seat system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer to confirm the problem.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check for LIN communication system DTCs.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B14B5 is not output | A |
| DTC B14B5 is output | B |
A
B
Refer to Problem Symptoms Table.
Click hereVehicle Interior>SEAT>CLIMATE CONTROL SEAT SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Terminals of ECU
Click hereVehicle Interior>SEAT>CLIMATE CONTROL SEAT SYSTEM>TERMINALS OF ECU
On-vehicle Inspection
Click hereVehicle Interior>SEAT>CLIMATE CONTROL SEAT SYSTEM>ON-VEHICLE INSPECTION
Inspection
Click hereVehicle Interior>SEAT>SEAT HEATER SWITCH>INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT