The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly RH removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY RH
89710C
2.REMOVE POSITION CONTROL ECU ASSEMBLY RH
|
Screw |
|
Connector |
Disconnect the 3 connectors.
Remove the 3 screws and position control ECU assembly RH.