This circuit is from the parking brake ECU (brake actuator assembly) to the radio and display receiver assembly.
Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.
The brake warning light operates as specified above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K2 radio and display receiver assembly connector.
Disconnect the A44 parking brake ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K2-20 (PKB) - A44-19 (PKB) | Always | Below 1 Ω |
| K2-20 (PKB) or A44-19 (PKB) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG