Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM33C0E _56 Audio / Visual / Telematics _065450 AUDIO / VIDEO _0333622 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E268439E59
0.344,2.802 1.542,3.313 1.198,0.51 10 false Radio and Display Receiver Assembly 0.354,2.646 0.906,2.99 0.552,0.344 10 false K4 0.979,0.646 1.323,0.885 0.344,0.24 10 false RL+ 1,1.417 1.344,1.656 0.344,0.24 10 false RL- 5.927,0.646 6.271,0.885 0.344,0.24 10 false II1+ 5.677,2.625 6.021,2.917 0.344,0.292 10 false K9 1.365,0.542 1.573,0.76 0.208,0.219 10 false 3 1.365,1.323 1.573,1.542 0.208,0.219 10 false 8 5.646,0.531 5.896,0.74 0.25,0.208 10 false 15 5.646,1.313 5.896,1.51 0.25,0.198 10 false 14 5.635,2.115 5.896,2.333 0.26,0.219 10 false 18 5.927,1.438 6.271,1.677 0.344,0.24 10 false II1- 5.927,2.219 6.417,2.427 0.49,0.208 10 false SLD1 3.26,1.75 4.01,1.969 0.75,0.219 10 false (Shielded) 5.667,2.792 6.875,3.208 1.208,0.417 10 false Stereo Component Amplifier Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the K4 radio and display receiver assembly connector.


b.

Disconnect the K9 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester connection Condition Specified condition
K4-3 (RL+) - K9-15 (II1+) Always Below 1 Ω
K4-8 (RL-) - K9-14 (II1-) Always Below 1 Ω
K9-18 (SLD1) - Body ground Always 10 kΩ or higher
K4-3 (RL+) or K9-15 (II1+) - Body ground Always 10 kΩ or higher
K4-8 (RL-) or K9-14 (II1-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR