Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM33C0E _58 Vehicle Interior _065455 DOOR LOCK _0333663 POWER DOOR LOCK CONTROL SYSTEM U

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body or Master Switch / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ACC SW Power switch on (ACC) signal OFF or ON OFF: Power switch off
ON: Power switch on (ACC)
-
IG SW Power switch on (IG) signal OFF or ON OFF: Power switch off or on (ACC)
ON: Power switch on (IG)
-
RR Door Courtesy SW Rear door courtesy light switch (for RH) signal OFF or ON OFF: Rear door RH closed
ON: Rear door RH open
-
RL Door Courtesy SW Rear door courtesy light switch (for LH) signal OFF or ON OFF: Rear door LH closed
ON: Rear door LH open
-
Door Lock SW-Lock Door control switch assembly lock signal*1 OFF or ON OFF: Lock side of door control switch assembly not pushed
ON: Lock side of door control switch assembly pushed
-
Door Lock SW-Unlock Door control switch assembly unlock signal*1 OFF or ON OFF: Unlock side of door control switch assembly not pushed
ON: Unlock side of door control switch assembly pushed
-
Door Key SW-Lock Driver door key-linked lock / unlock switch lock signal OFF or ON OFF: Driver door key cylinder not turned to lock position
ON: Driver door key cylinder turned to lock position
-
D Door Key SW-UL Driver door key-linked lock / unlock switch unlock signal OFF or ON OFF: Driver door key cylinder not turned to unlock position
ON: Driver door key cylinder turned to unlock position
-
FR Door Lock Pos Front door RH unlock detection switch signal LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy SW Front door courtesy light switch (for RH) signal OFF or ON OFF: Front door RH closed
ON: Front door RH open
-
FL Door Lock Pos Front door LH unlock detection switch signal LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy SW Front door courtesy light switch (for LH) signal OFF or ON OFF: Front door LH closed
ON: Front door LH open
-
RR-Door Lock Pos SW Rear door RH unlock detection switch signal OFF or ON OFF: Rear door RH locked
ON: Rear door RH unlocked
-
RL-Door Lock Pos SW Rear door LH unlock detection switch signal OFF or ON OFF: Rear door LH locked
ON: Rear door LH unlocked
-
Unlock Key Twice Key-linked 2-step unlock function OFF or ON Customize setting displayed -
Auto Lock Speed-sensitive automatic door lock function*2 OFF or ON Customize setting displayed -
Auto Lock/Shift Shift-linked automatic door lock function *2 OFF or ON Customize setting displayed -
Auto Unlock/Shift Shift-linked automatic door unlock function*2 OFF or ON Customize setting displayed -
All Unlock/Open-Close Driver door-linked automatic door unlock function*2 OFF or ON Customize setting displayed -
The Number of DTC Number of trouble codes 0 to 255 Number of stored DTCs displayed -

*1: w/ Canister Pump Module

*2: w/ Auto Lock Function


Body Electrical > Master Switch > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Door Lock Switch Status Multiplex network master switch assembly lock signal OFF or ON OFF: Lock side of multiplex network master switch assembly not pushed
ON: Lock side of multiplex network master switch assembly pushed
-
Door Unlock Switch Status Multiplex network master switch assembly unlock signal OFF or ON OFF: Unlock side of multiplex network master switch assembly not pushed
ON: Unlock side of multiplex network master switch assembly pushed
-


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Door Lock Door lock motor OFF/Unlock/Lock -
D-Door Unlock Driver door lock motor OFF/ON -
Shock Detection Unlock Operate door lock motor UNLOCK/LOCK -