The main body ECU (multiplex network body ECU) receives switch signals from the door control switch assembly and activates the door lock motor on each door according to these signals.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Door Lock SW-Lock | Door control switch assembly lock signal | OFF or ON | OFF: Lock side of door control switch assembly not pushed
ON: Lock side of door control switch assembly pushed |
- |
| Door Lock SW-Unlock | Door control switch assembly unlock signal | OFF or ON | OFF: Unlock side of door control switch assembly not pushed
ON: Unlock side of door control switch assembly pushed |
- |
| Tester Display |
|---|
| Door Lock SW-Lock |
| Door Lock SW-Unlock |
The GTS indicates ON or OFF according to the switch operation shown in the table.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the door control switch assembly.
Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL SWITCH>REMOVAL
Inspect the door control switch assembly.
Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3A and 3B instrument panel junction block assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N4-2 (UL) - 3A-39 | Always | Below 1 Ω |
| N4-4 (L) - 3B-16 | Always | Below 1 Ω |
| N4-5 (E) - Body ground | Always | Below 1 Ω |
| 3A-39 or N4-2 (UL) - Other terminals and body ground | Always | 10 kΩ or higher |
| 3B-16 or N4-4 (L) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU).
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| MB-22 (UL1) - 3A-39 | Always | Below 1 Ω |
| MB-20 (L1) - 3B-16 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG