Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM33C0E _58 Vehicle Interior _065455 DOOR LOCK _0333669 REAR DOOR LOCK G

DOOR LOCK  REAR DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69060A 1.INSPECT REAR DOOR LOCK WITH MOTOR ASSEMBLY LH

a.
B340417C21
2.042,2.146 2.354,2.302 0.313,0.156 10 false *a 1.656,2.271 1.969,2.427 0.313,0.156 10 false *b 0.833,2.917 1.146,3.073 0.313,0.156 10 false *c
*a Unlock
*b Lock
*c Component without harness connected
(Rear Door Lock with Motor Assembly LH)


Check the operation of the door lock motor.

i.

Apply auxiliary battery voltage and check the operation of the door lock motor.

OK:
Auxiliary Battery Connection Result
Auxiliary battery positive (+) → Terminal 4
Auxiliary battery negative (-) → Terminal 1
Locks
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 4
Unlocks


If the result is not as specified, replace the rear door lock with motor assembly LH.



b.

Check the operation of the unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 - 9 Locked 10 kΩ or higher
6 - 9 Unlocked Below 1 Ω


If the result is not as specified, replace the rear door lock with motor assembly LH.



Hide 69050A 2.INSPECT REAR DOOR LOCK WITH MOTOR ASSEMBLY RH

a.
B340416C20
1.042,2.083 1.354,2.24 0.313,0.156 10 false *a 1.604,2.313 1.917,2.469 0.313,0.156 10 false *b 0.854,2.906 1.167,3.063 0.313,0.156 10 false *c
*a Unlock
*b Lock
*c Component without harness connected
(Rear Door Lock with Motor Assembly RH)


Check the operation of the door lock motor.

i.

Apply auxiliary battery voltage and check the operation of the door lock motor.

OK:
Auxiliary Battery Connection Result
Auxiliary battery positive (+) → Terminal 4
Auxiliary battery negative (-) → Terminal 1
Locks
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 4
Unlocks


If the result is not as specified, replace the rear door lock with motor assembly RH.



b.

Check the operation of the unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 - 9 Locked 10 kΩ or higher
6 - 9 Unlocked Below 1 Ω


If the result is not as specified, replace the rear door lock with motor assembly RH.