Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (w/o Tire Pressure Warning System)
RM33C0E _58 Vehicle Interior _065455 DOOR LOCK _0333672 DOOR CONTROL RECEIVER(w/o Tire Pressure Warning System) A

DOOR LOCK  DOOR CONTROL RECEIVER(w/o Tire Pressure Warning System)  REMOVAL  


PROCEDURE

Hide 73350C 1.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)

Hide 2.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

Hide 72693 3.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

Hide 62331A 4.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL


Hide 5.REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL


Hide 71940A 6.REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)

Hide 73350C 7.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Reclining Seat Type)

Hide 8.REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)

Hide 72693 9.REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)

Hide 72996A 10.REMOVE REAR SEATBACK COVER (for Reclining Seat Type)

Hide 11.REMOVE REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)

Hide 62331A 12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Reclining Seat Type)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>REMOVAL


Hide 13.REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Reclining Seat Type)

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>REMOVAL


Hide 62471A 14.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 89740A 15.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY

NOTICE:
·

Do not drop, strike or otherwise subject the smart door control receiver assembly to impact.

·

If the smart door control receiver assembly is subjected to an impact, replace it with a new one.



a.
B479884

Remove the bolt.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the smart door control receiver assembly.