Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM33C0E _59 Vehicle Exterior _065469 DOOR / HATCH _0333678 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 53482 1.INSTALL HOOD SUPPORT BRACKET

a.

Engage the guide.


b.

Install the hood support bracket with the bolt.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)


Hide 53337C 2.INSTALL HOOD STAY BRACKET

a.

Engage the guide.


b.

Install the hood stay bracket with the bolt.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)


Hide 53450A 3.INSTALL HOOD SUPPORT ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the hood support assembly in order to prevent the piston rod from deforming.



a.
B469195

Engage the 2 ball joints to install the hood support assembly.

NOTICE:

Install the hood support assembly while supporting the hood by hand.



b.

Check that the ball joints are engaged securely and the hood support assembly cannot be pulled off.


Hide 53826A 4.INSTALL FRONT FENDER UPPER PROTECTOR

a.

Engage the 4 clips to install the front fender upper protector.