Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM33C0E _59 Vehicle Exterior _065469 DOOR / HATCH _0333678 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 53826A 1.REMOVE FRONT FENDER UPPER PROTECTOR

a.
B469193

Disengage the 4 clips to remove the front fender upper protector.


Hide 53450A 2.REMOVE HOOD SUPPORT ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the hood support assembly in order to prevent the piston rod from deforming.



a.
B469191C01
0.5,1.01 0.76,0.823 true 0.708,2.458 1.042,2.292 true 0.26,0.938 0.5,1.135 0.24,0.198 10 true *a 1.063,2.177 1.302,2.375 0.24,0.198 10 true *a
*a Protective Tape
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Using a screwdriver with its tip wrapped with protective tape, slightly raise the 2 stop rings as indicated by the arrows, in the order shown in the illustration.

NOTICE:
·

Do not remove the stop rings from the hood support assembly. Raise the stop rings just enough to allow the ball joints to be disengaged.

·

Do not reuse the hood support assembly if a stop ring has been removed.




b.

Disengage the 2 ball joints to remove the hood support assembly.

NOTICE:

Remove the hood support assembly while supporting the hood sub-assembly by hand.



Hide 53337C 3.REMOVE HOOD STAY BRACKET

a.
B469192

Remove the bolt.


b.

Disengage the guide to remove the hood stay bracket.


Hide 53482 4.REMOVE HOOD SUPPORT BRACKET

a.
B469194

Remove the bolt.


b.

Disengage the guide to remove the hood support bracket.