Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR SUPPORT
RM33C0E _59 Vehicle Exterior _065469 DOOR / HATCH _0333686 LUGGAGE COMPARTMENT DOOR SUPPORT A

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

After installing the luggage compartment door support assembly, use your hand to open and close the luggage door. Make sure the luggage door can open and close smoothly.


PROCEDURE

Hide 64530A 1.INSTALL LUGGAGE COMPARTMENT DOOR SUPPORT ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the luggage compartment door support assembly in order to prevent the piston rod from deforming.



a.
B471700C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Engage the guide as indicated by the arrows, in the order shown in the illustration.


b.
B471701

Engage the ball joint to install the luggage compartment door support assembly.

NOTICE:

Install the luggage compartment door support assembly while supporting the luggage door by hand.



c.

Check that the ball joint is engaged securely and the luggage compartment door support assembly cannot be pulled off.


Hide 64519 2.INSTALL LUGGAGE DOOR HINGE SUPPORT BUSH

a.

Engage the 2 claws to install the luggage door hinge support bush.

HINT:

Use the same procedure for the RH side and LH side.



Hide 65776 3.INSTALL BACK DOOR STAY SPRING

a.
B471696C01
1.938,1.719 2.271,1.427 true 1.719,1.646 1.938,1.865 0.219,0.219 10 true *a
*a Alignment Mark (Blue)


Engage the 2 guides to install the back door stay spring.

NOTICE:

Make sure that the alignment mark (blue) is on the rear inner side.


HINT:

Use the same procedure for the RH side and LH side.



Hide 64722 4.INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER LH

a.

Engage each fastener to install the luggage compartment trim inner cover LH.


b.

Install the 2 clips.


Hide 64721 5.INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH

a.

Engage each fastener to install the luggage compartment trim inner cover RH.


b.

Install the 2 clips.


Hide 58387 6.INSTALL REAR FLOOR FINISH PLATE

a.
B471734C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 4 claws and 8 guides to install the rear floor finish plate as shown in the illustration.


b.

Install the 4 clips.


Hide 64749E 7.INSTALL LUGGAGE COMPARTMENT DOOR STRIKER COVER

a.
B471738C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 2 claws to install the luggage compartment door striker cover as shown in the illustration.


Hide 64725D 8.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

a.
B471726

Engage the guide and claw to install the No. 1 luggage compartment trim hook.

HINT:

Use the same procedure for the RH side and LH side.



Hide 64779E 9.INSTALL SPARE WHEEL COVER TRAY

a.

Install the spare wheel cover tray.


Hide 64770 10.INSTALL SPARE WHEEL COVER ASSEMBLY

a.

Install the spare wheel cover assembly.