84840
1.INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY
| *a | Component without harness connected
(Luggage Compartment Door Opening Switch Assembly) |
Check the switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 5 | Pressed (ON) | Below 25 Ω |
| 2 - 5 | Not pressed (OFF) | 1 MΩ or higher |
If the result is not as specified, replace the luggage compartment door opening switch assembly.
Check the switch illumination.
Apply auxiliary battery voltage to the switch connector and check that the luggage compartment door opening switch assembly illuminates.
| Auxiliary Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6
Auxiliary battery negative (-) → Terminal 1 |
Illumination illuminates |
If the result is not as specified, replace the luggage compartment door opening switch assembly.