The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
67492A
4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74038A
5.REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
6.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
7.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74220
8.REMOVE FRONT ARMREST ASSEMBLY
81230
9.REMOVE COURTESY LIGHT ASSEMBLY
67602
10.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
11.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
67832
12.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
13.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
14.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY
85720D
15.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.