CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
| *A | w/o Seat Heater | *B | w/ Seat Heater |
Disconnect the K54 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K54-2 (IG+) - K54-4 (GND) | LA-GR - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| K54-2 (IG+) - K54-4 (GND) | LA-GR - W-B | Power source (IG) | Power switch off | Below 1 V |
| K54-1 (B) - K54-4 (GND) | LA-B - W-B | Auxiliary battery power supply | Power switch off | 11 to 14 V |
| K54-4 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the K54 air conditioning amplifier assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K54-5 (RDFG) - K54-4 (GND) | L - W-B | Rear window defogger signal | Power switch on (IG), rear window defogger switch off | 11 to 14 V |
| K54-5 (RDFG) - K54-4 (GND) | L - W-B | Rear window defogger signal | Power switch on (IG), rear window defogger switch on | Below 1 V |
| K54-14 (LIN1) - K54-4 (GND)* | BE - W-B | LIN communication line | Power switch on (IG) | Pulse generation |
*: except 8 Inch Display
CHECK AIR CONDITIONING CONTROL ASSEMBLY (except 8 Inch Display)
Disconnect the K26 air conditioning control assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K26-2 (IG+) - K26-6 (GND) | GR - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| K26-2 (IG+) - K26-6 (GND) | GR - W-B | Power source (IG) | Power switch off | Below 1 V |
| K26-6 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the K26 air conditioning control assembly connector.
Check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K26-9 (LIN1) - K26-6 (GND) | LG - W-B | LIN communication line | Power switch on (IG) | Pulse generation |
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY (for 8 Inch Display)
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>TERMINALS OF ECU