Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2017.09–2019.02
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0333719 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.


PROCEDURE

Hide 81498 1.REMOVE REAR COMBINATION LIGHT COVER LH

Hide 81497 2.REMOVE REAR COMBINATION LIGHT COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B470428C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear bumper assembly as shown in the illustration.


b.
B470431

Remove the 2 screws.


c.
B470429

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



d.
B490259

Remove the 9 clips.


e.
B488725C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 6 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B470435C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 4 claws and 2 guides to remove the rear bumper assembly as shown in the illustration.


g.

Disconnect the connector to remove the rear bumper assembly.