Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75862Q
1.REMOVE FRONT ROCKER PANEL MOULDING END COVER
75852
2.REMOVE ROCKER PANEL MOULDING
Apply protective tape around the rocker panel moulding and doors as shown in the illustration.
|
Protective Tape | - | - |
Remove the 8 clips.
Remove the 6 screws.
| *1 | Grommet | - | - |
Remove the grommet
Disengage the 9 clips to remove the rocker panel moulding as shown in the illustration.
|
Remove in this Direction | - | - |