Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75547C
1.INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP
Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.
Using a riveter with a nose piece, install 6 new No. 3 windshield outside moulding clips.
If the mandrel of the No. 3 windshield outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.
| *a | Riveter |
| *b | Mandrel |
| *c | Incorrect |
Do not pry the No. 3 windshield outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.
| *a | Riveter |
| *b | Incorrect |
| *c | Correct |
Confirm that the No. 3 windshield outside moulding clips are seated properly against the vehicle body.
Do not tilt the riveter when installing the No. 3 windshield outside moulding clip to the vehicle body.
Install the windshield glass sub-assembly.
Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD GLASS>INSTALLATION
75545B
2.INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP
Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.
Engage the 6 claws to install the 6 No. 1 windshield outside moulding clips as shown in the illustration.
|
Install in this Direction | - | - |
75536D
3.INSTALL WINDSHIELD OUTSIDE MOULDING
Engage the 12 claws to install the windshield outside moulding.
53867H
4.INSTALL FRONT FENDER TO COWL SIDE SEAL