Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2017.09–2021.02
RM33C0E _56 Audio / Visual / Telematics _065451 NAVIGATION / MULTI INFO DISPLAY _0333738 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.

The sound signal that has been sent is amplified by the radio and display receiver assembly and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E351362E17
3.271,2.813 4.115,3.125 0.844,0.313 10 false (Shielded) 0.823,0.615 1.344,0.896 0.521,0.281 10 false ADPG 0.833,1.229 1.354,1.51 0.521,0.281 10 false VAR+ 0.948,2.406 1.469,2.688 0.521,0.281 10 false VA- 0.833,2.99 1.354,3.271 0.521,0.281 10 false AGND 0.448,3.458 0.969,3.74 0.521,0.281 10 false K5 0.448,3.625 1.635,4.083 1.188,0.458 10 false No. 1 Stereo Jack Adapter Assembly 1.313,0.531 1.833,0.813 0.521,0.281 10 false 5 1.313,1.115 1.833,1.396 0.521,0.281 10 false 2 1.313,1.708 1.833,1.99 0.521,0.281 10 false 3 1.313,2.292 1.833,2.573 0.521,0.281 10 false 4 1.333,2.896 1.854,3.177 0.521,0.281 10 false 6 5.688,0.531 6.208,0.813 0.521,0.281 10 false 14 5.698,1.719 6.219,2 0.521,0.281 10 false 11 5.688,2.313 6.208,2.594 0.521,0.281 10 false 13 5.698,2.896 6.219,3.177 0.521,0.281 10 false 10 5.823,3.448 6.344,3.729 0.521,0.281 10 false K3 5.823,3.604 7.052,4.271 1.229,0.667 10 false Radio and Display Receiver Assembly 0.865,1.813 1.385,2.094 0.521,0.281 10 false VAL+ 5.958,0.625 6.479,0.906 0.521,0.281 10 false ADPG 5.969,1.219 6.49,1.5 0.521,0.281 10 false VAR+ 5.698,1.135 6.219,1.417 0.521,0.281 10 false 12 5.969,1.823 6.49,2.104 0.521,0.281 10 false VAL+ 5.958,2.417 6.479,2.698 0.521,0.281 10 false VA- 5.958,3 6.479,3.281 0.521,0.281 10 false AGND

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the K3 radio and display receiver assembly connector.


b.

Disconnect the K5 No. 1 stereo jack adapter assembly connector.


c.
E360494C01
1.563,2.458 1.938,2.729 0.375,0.271 1.542,0.281 1.927,0.542 0.385,0.26 1.594,3.594 1.073,3.042 false 1.469,3.604 0.969,3.302 false 1.698,3.615 1.302,2.833 false 1.938,3.635 2.438,3.271 false 1.823,3.615 2.208,2.979 false 1.844,1.583 2.073,0.792 false 2.021,1.573 2.74,1.031 false 1.906,1.594 2.563,0.781 false 1.604,1.594 1.115,0.99 false 2.167,1.583 2.771,1.385 false 0.26,2.469 0.573,2.667 0.313,0.198 10 false *b 1.656,0.344 1.969,0.542 0.313,0.198 10 false K3 1.667,2.51 1.979,2.708 0.313,0.198 10 false K5 0.25,0.146 0.563,0.344 0.313,0.198 10 false *a 1.948,0.625 2.333,0.823 0.385,0.198 10 false VAL+ 2.469,0.625 2.885,0.823 0.417,0.198 10 false VAR+ 2.771,0.917 3.083,1.115 0.313,0.198 10 false VA- 2.813,1.292 3.25,1.51 0.438,0.219 10 false ADPG 0.875,0.802 1.448,1.021 0.573,0.219 10 false AGND 2.385,3.104 2.958,3.323 0.573,0.219 10 false AGND 0.896,2.865 1.313,3.063 0.417,0.198 10 false VAL+ 1.188,2.667 1.573,2.865 0.385,0.198 10 false VA- 0.698,3.135 1.156,3.333 0.458,0.198 10 false VAR+ 2.073,2.813 2.51,3.031 0.438,0.219 10 false ADPG
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K3-14 (ADPG) - K5-5 (ADPG) Always Below 1 Ω
K3-10 (AGND) - K5-6 (AGND) Always Below 1 Ω
K3-12 (VAR+) - K5-2 (VAR+) Always Below 1 Ω
K3-11 (VAL+) - K5-3 (VAL+) Always Below 1 Ω
K3-13 (VA-) - K5-4 (VA-) Always Below 1 Ω
K3-14 (ADPG) or K5-5 (ADPG) - Body ground Always 10 kΩ or higher
K3-10 (AGND) or K5-6 (AGND) - Body ground Always 10 kΩ or higher
K3-12 (VAR+) or K5-2 (VAR+) - Body ground Always 10 kΩ or higher
K3-11 (VAL+) or K5-3 (VAL+) - Body ground Always 10 kΩ or higher
K3-13 (VA-) or K5-4 (VA-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR