Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM33C0E _56 Audio / Visual / Telematics _065451 NAVIGATION / MULTI INFO DISPLAY _0333738 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake ECU (brake actuator assembly) to the radio and display receiver assembly.

WIRING DIAGRAM

E372242E17
2.5,1.479 3.104,1.719 0.604,0.24 10 false A44 2.5,1.646 4.156,2.167 1.656,0.521 10 false Parking Brake ECU (Brake Actuator Assembly) 3.719,0.969 4.323,1.208 0.604,0.24 10 false 19 5.219,1.99 5.823,2.229 0.604,0.24 10 false K2 5.219,2.146 6.406,2.594 1.188,0.448 10 false Radio and Display Receiver Assembly 5.417,1.083 6.021,1.323 0.604,0.24 10 false PKB 5.146,0.99 5.75,1.229 0.604,0.24 10 false 20 3.302,1.115 3.906,1.354 0.604,0.24 10 false PKB

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the K2 radio and display receiver assembly connector.


b.

Disconnect the A44 parking brake ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K2-20 (PKB) - A44-19 (PKB) Always Below 1 Ω
K2-20 (PKB) or A44-19 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR