Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0333740 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E240921E27
5.563,0.479 5.729,0.646 0.167,0.167 10 false IG 5.271,0.385 5.729,0.74 0.458,0.354 10 false 1 5.563,1.292 5.729,1.458 0.167,0.167 10 false E 5.448,1.729 5.948,1.969 0.5,0.24 10 false R39 3.188,0.646 4.271,0.875 1.083,0.229 10 false ECU-IG1 NO. 4 0.146,0.458 1.635,0.813 1.49,0.354 10 false from IG1-NO. 1 Relay 5.448,1.906 6.719,2.292 1.271,0.385 10 false Clearance Warning ECU Assembly 5.292,1.188 5.469,1.354 0.177,0.167 10 false 30

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)
a.

Disconnect the R39 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
R39-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
R39-1 (IG) - Body ground Power switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R39-30 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR