CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM
Customizing with the GTS.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the TOYOTA parking assist-sensor system on.
Turn the GTS on.
Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility / Customize Setting.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Fr Corner Sensor Onset Range | Sets the detection operation range for the front corner sensors. | Long | 0:Short,1:Long | Clearance warning ECU assembly |
| Rr Corner Sensor Onset Range | Sets the detection operation range for the rear corner sensors. | Long | 0:Short,1:Long | Clearance warning ECU assembly |
| Fr Sensor Onset Range | Sets the detection operation range for the front corner sensors. | Wide | 0:Narrow,1:Wide | Clearance warning ECU assembly |
| Rr Sensor Onset Range | Sets the detection operation range for the rear center sensors. | Wide | 0:Narrow,1:Wide | Clearance warning ECU assembly |
| Fr & Rr Buzzer Volume | Changes the buzzer volume setting. | M | 01:L,10:M,11:H | Clearance warning ECU assembly |
| Object Not Moving 3s Buzz Vol | Sets the volume at which the buzzer sounds when the distance between the vehicle and a detected object does not change for 3 seconds. | Keep | 00:Keep Vol,01:L,10:M1,11:M2 | Clearance warning ECU assembly |
| Leave Buzzer Volume | Sets the volume of the buzzer with respect to the distance between the vehicle and a detected object. | L | 00:Keep Vol,01:L,10:M1,11:M2 | Clearance warning ECU assembly |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Sensor Condition N | Makes the front sensors available when the shift lever is in N. | Avail | 0:Not Avail,1:Avail | Clearance warning ECU assembly |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Approach Display OFF | Sets whether the display turns off after an obstacle is no longer detected. | Avail | 0:Not Avail,1:Avail | Clearance warning ECU assembly |