Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0333740 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System)  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Registration of bumper type Procedure 1
Ultrasonic sensor Initialization of front corner ultrasonic sensor (LH, RH) Procedure 2
Initialization of rear corner ultrasonic sensor (LH, RH)



Registration of Bumper Type (PROCEDURE 1)



b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

f.

Select "Clearance Sonar ECU" and perform steering adjustment according to the display on the GTS.


g.

Enter the bumper type using the GTS.

Bumper Type Value
for Bar Type Radiator Grill 1
for Mesh Type Radiator Grill 2


h.

Disconnect the GTS from the DLC3.



Registration of Ultrasonic Sensors (PROCEDURE 2)



b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

f.

Select "Fr Sensor or Bumper" or "Rr Sensor or Bumper" and perform automatic adjustment according to the display on the GTS.

HINT:

It is not required to enter sensor angles. Perform the procedure according to the display on the GTS.



g.

Disconnect the GTS from the DLC3.