Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2017.09–2018.04
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0333742 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB0  Short to +B in Outer Mirror Indicator(Master)  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB0 Short to +B in Outer Mirror Indicator(Master)
Both of the following conditions are met:
·

The blind spot monitor system is on


·

The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time


·

Outer mirror RH

·

Outer rear view mirror assembly with cover RH

·

Wire harness or connector

·

Blind spot monitor sensor RH



WIRING DIAGRAM

E372912E03
5.958,1.229 6.573,1.427 0.615,0.198 10 false OMIR 2.031,1.135 2.646,1.333 0.615,0.198 10 false BSR+ 2.302,1.646 2.458,1.844 0.156,0.198 10 false - 0.281,2.063 0.896,2.26 0.615,0.198 10 false IND1 0.271,2.219 1.906,2.427 1.635,0.208 10 false Outer Mirror RH 0.188,3.333 0.646,3.531 0.458,0.198 10 false N19 0.167,3.5 7.042,3.698 6.875,0.198 10 false Outer Rear View Mirror Assembly With Cover RH 5.813,3.354 6.125,3.552 0.313,0.198 10 false W5 5.823,3.5 7,4.385 1.177,0.885 10 false Blind Spot Monitor Sensor RH 5.781,1.156 5.938,1.354 0.156,0.198 10 false 4 2.49,1.135 2.646,1.333 0.156,0.198 10 false 3 2.469,1.646 2.781,1.844 0.313,0.198 10 false 11 3.271,1.552 3.583,1.75 0.313,0.198 10 false 12 3.594,1.729 4.135,2 0.542,0.271 10 false HTR- 4.427,1.74 4.885,1.938 0.458,0.198 10 false GND 4.917,1.552 5.073,1.75 0.156,0.198 10 false 7 2.927,2.167 5.542,2.438 2.615,0.271 10 false Outer Mirror Control ECU Assembly RH 1.375,1.229 1.531,1.427 0.156,0.198 10 false + 1.396,1.719 1.552,1.917 0.156,0.198 10 false - 1.594,1.146 1.75,1.344 0.156,0.198 10 false 2 1.594,1.625 1.75,1.823 0.156,0.198 10 false 1 0.26,2.385 2.281,2.854 2.021,0.469 10 false (Outer Rear View Mirror Indicator RH) 3.24,1.729 3.667,1.938 0.427,0.208 10 false N10 4.865,1.729 5.115,1.917 0.25,0.188 10 false N9


CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Turn the power switch on (IG).


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
a.

Disconnect the W5 blind spot monitor sensor RH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
W5-4 (OMIR) - Body ground Power switch on (IG) Below 1 V



Result:
Proceed to
OK
NG



OK

NG

3.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
3.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
a.

Disconnect the IND1 outer mirror RH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
W5-4 (OMIR) - Body ground Power switch on (IG) Below 1 V



Result:
Proceed to
OK
NG



OK

NG

4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR CIRCUIT)
a.

Disconnect the N19 outer rear view mirror assembly with cover RH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
W5-4 (OMIR) - Body ground Power switch on (IG) Below 1 V



Result:
Proceed to
OK
NG



OK

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR