Home › General › MAINTENANCE › FRONT WIPER RUBBER
RM33C0E _V1 General _065432 MAINTENANCE _0334211 FRONT WIPER RUBBER A

MAINTENANCE  FRONT WIPER RUBBER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blade.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 85222A 1.REMOVE FRONT WIPER BLADE

a.

Turn the power switch on (IG).


b.

Turn the power switch off and move the windshield wiper switch assembly to the MIST position and hold it for 2 seconds or more.

HINT:

If the front wiper arm and blade assemblies do not move to the service position, turn the power switch on (IG) and then perform this step again.



c.
E370243C01
1.885,1.583 1.604,1.125 true 1.594,4.104 1.313,3.646 true 1.594,4.135 1.906,4.292 0.313,0.156 10 false *a 1.865,1.604 2.177,1.76 0.313,0.156 10 false *a
*a Holder
V113147

Remove in this Direction


Pull up the holder of the front wiper blade.


d.
E370246C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the front wiper blade from the front wiper arm as shown in the illustration.

NOTICE:

Place a piece of cloth between the front wiper arm and windshield glass to avoid damaging the windshield glass.



Hide 85214B 2.REMOVE WIPER RUBBER

a.
E370247C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the wiper rubber with the front wiper rubber backing plates from the front wiper blade.


b.
E370248C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the 2 front wiper rubber backing plates from the wiper rubber.